Equipment operation not following Set Points/Temp

• Related Articles

• What does the master set point do?

  The master set point is a quick way to alter the set points of all the equipment in a zone. When the master set point is changed, all the equipment set points in that zone are changed proportionally.

• How do I set up alerts/alarms?

  You must individually configure the alarms for each piece of equipment. You must also set up the active time and communication methods in the Alert Schedule, found in the Administration menu.

• Air curtain operation explained

  Air curtain settings This is the status and physical order of the air curtain bags. The numbers correspond with blower numbers in item B. This is the list of blowers, in the order they inflate. The blower button that is selected is the one that you ...

• Why does my equipment still run when the output is at 0 percent?

  Some equipment may still operate at a very low value at 0 percent. Use the disconnect relay to fully cut off the power to the equipment and ensure that 0 percent means fully off. See Connect Equipment in the user manual for more information.

• Why can’t I adjust the set point?

  If the growth curve is enabled you cannot adjust the set point. See To start or stop the growth curve in the user manual for more information.