Why can’t I adjust the set point?

• Related Articles

• What does the master set point do?

  The master set point is a quick way to alter the set points of all the equipment in a zone. When the master set point is changed, all the equipment set points in that zone are changed proportionally.

• Why do I get GcEn when I try to change the set point?

  The growth curve is enabled. Either alter the growth curve settings as desired, or disable the growth curve and change the set point to the desired setting. Note, changing the set point and then re-enabling the growth curve is pointless. The growth ...

• Equipment operation not following Set Points/Temp

  After confirming program being changed and program being ran are the same, and all set points are valid, I recommended factory defaulting the control, setting it up again with the same programming.

• How do I set up alerts/alarms?

  You must individually configure the alarms for each piece of equipment. You must also set up the active time and communication methods in the Alert Schedule, found in the Administration menu.

• Why can't I adjust the idle speed of my variable fan in my Plus-Touch?

  If you cannot adjust the idle speed of your variable fan, and are just seeing three dashes rather than a number, you have the Minimum Ventilation Curve active for that zone. Go to Menu, Configuration, Zone Control Mode, and disable the Minimum ...