Why do I get GcEn when I try to change the set point?
The
growth curve is enabled. Either alter the growth curve settings as desired, or
disable the growth curve and change the set point to the desired setting. Note,
changing the set point and then re-enabling the growth curve is pointless. The
growth curve overrides the set point when it is enabled.
Related Articles
What does the master set point do?
The master set point is a quick way to alter the set points of all the equipment in a zone. When the master set point is changed, all the equipment set points in that zone are changed proportionally.
Why can’t I adjust the set point?
If the growth curve is enabled you cannot adjust the set point. See To start or stop the growth curve in the user manual for more information.
Equipment operation not following Set Points/Temp
After confirming program being changed and program being ran are the same, and all set points are valid, I recommended factory defaulting the control, setting it up again with the same programming.
Temperature does not change
Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...
Temperature does not change
Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...