Can I use a duty cycle on my Var fan?

Can I use a duty cycle on my Var fan?

The only stage with proportional heat/cooling control is stage 5. Technically you could wire one of your variable fans in series with stage 5 so it intermittently disconnected the source voltage as the setpoint calls for it.

    • Related Articles

    • Can I do minimum ventilation duty cycles on the AutoFlex Connect?

      There is not a simple software way of doing this, but there is a way. Wire the output of the variable through a relay before it goes to the fan. (L1 goes to one VAR terminal, the second VAR terminal goes to the relay, and then the second relay ...

    • Variable fan runs at maximum

      Problem Variable fan runs at maximum Possible Cause Possible Solution Incorrect wiring Correct the wiring. The fuse is open or blown. Check why the fuse was blown and repair any problems. Replace the fuse. The variable stage is configured as OFF ...

    • Variable fan runs at maximum

      Problem Variable fan runs at maximum Possible Cause Possible Solution Incorrect wiring Correct the wiring. The fuse is open or blown. Check why the fuse was blown and repair any problems. Replace the fuse. The variable stage is configured as OFF ...

    • Variable fan runs at maximum

      Problem Variable fan runs at maximum Possible Cause Possible Solution Incorrect wiring Correct the wiring. The fuse is open or blown. Check why the fuse was blown and repair any problems. Replace the fuse. The variable stage is configured as OFF ...

    • Troubleshooting - Variable fan runs at maximum

      Problem Variable fan runs at maximum Possible Cause Possible Solution Incorrect wiring Correct the wiring. The fuse is open or blown. Check why the fuse was blown and repair any problems. Replace the fuse. The variable stage is configured as OFF ...