How can I control the humidity caused by my cooling cells?
By using Stage 5's proportional cooling, you can truly run your cooling cells as evaporative cooling, by setting them to turn the pump on and off according to the proportional cycle. This will allow the fan to run by itself and pull the excess humidity out of the barn before turning on the pump again.
Related Articles
Can I control a pump strictly off humidity?
Most equipment controlled from the PLUS-TOUCH must use temperature as a primary control mode. However if they set up a Cooling relay with a very high value setpoint, it should never turn on from temperature. Then, you can set up secondary modifiers ...
Questions about troubleshooting load cells
The following information is available in the troubleshooting section of all scale head manuals. 1. Make sure the cage is not hitting against anything (for example, the floor, dung, part of the frame). The only contact points must be the load cell ...
Can the FC-1T-2VAC-3F control variable heaters?
No, the two variable stages are for cooling only. The three relay stages can control either cooling or heating. The Plus-Touch can control variable heaters.
Is there a way to change the behaviour based on humidity levels?
Yes. The high humidity bypass allows you to monitor humidity levels and skip the water portion of the cycle and only run the fan portion if the humidity is too high.
How do I configure my stages for heating or cooling?
Stages 3, 4, and 5 can be configured for either heating or cooling. Do this through the Configuration menu. See the user manual for step-by-step instructions.