How do I set up Modifiers?

• Related Articles

• Does hysteresis affect modifiers in the AutoFlex Connect?

  Yes, hysteresis does affect modifiers. The hysteresis kicks in when the modifier is active so that, in general, the set point to deactivate the modifier is: Original modifier value + hysteresis (for ‘is less than value’ modifiers) Original modifier ...

• What does the master set point do?

  The master set point is a quick way to alter the set points of all the equipment in a zone. When the master set point is changed, all the equipment set points in that zone are changed proportionally.

• Can I control a pump strictly off humidity?

  Most equipment controlled from the PLUS-TOUCH must use temperature as a primary control mode. However if they set up a Cooling relay with a very high value setpoint, it should never turn on from temperature. Then, you can set up secondary modifiers ...

• Equipment operation not following Set Points/Temp

  After confirming program being changed and program being ran are the same, and all set points are valid, I recommended factory defaulting the control, setting it up again with the same programming.

• How do I set up alerts/alarms?

  You must individually configure the alarms for each piece of equipment. You must also set up the active time and communication methods in the Alert Schedule, found in the Administration menu.