How do I install the VDC-4 module?

• Related Articles

• Configuring a shut off for light fixtures on a VDC-4 R1

  Installing and configuring a shutoff for light fixtures Follow this procedure if your light fixtures need less than 0.5 VDC to be off and the fixtures are connected to a VDC-4 module version R1. You can find the version information at the location ...

• Can I install Omni Select on a Chromebook?

  No. Omni Select is incompatible with Chromebooks. You must install the Omni Select software on a Windows computer.

• Module slot #9 doesn't fit the VAC-1 module

  Because of the design of the module and the placement of the screw that holds the board in the enclosure, a VAC-1 module will not properly sit in Module #9 of the AutoFlex. Use this slot for other modules.

• Controlling 0 - 10 volt dc lighting with the VDC-4

  This article is for general information. Always refer to local electrical codes for acceptable installations. This article addresses 0-10 volt dc controlled light fixtures. While the main focus will be on LED lighting, the information could be ...

• Can the AutoFlex Connect work with the VES-Artex Turntide Fans?

  Yes, the AutoFlex can control Turntide fans with a 0-10 VDC signal from VDC-4 module.