Module slot #9 doesn't fit the VAC-1 module

Module slot #9 doesn't fit the VAC-1 module

Because of the design of the module and the placement of the screw that holds the board in the enclosure, a VAC-1 module will not properly sit in Module #9 of the AutoFlex. Use this slot for other modules.
    • Related Articles

    • Does the neutral from the load need to go to the terminal on the VAC-1 ?

      Yes. The neutral from the load must go to the terminal on the VAC-1, it cannot go straight from the load to the panel.
    • How do I install the VDC-4 module?

      The VDC-4 module is installed into the Display side of your PLUS-TOUCH controller, there are 4 stand-offs where it will be secured by screws. Refer to the PLUS-TOUCH installation guide for pictures and more information.
    • Why can’t I adjust the set point?

      If the growth curve is enabled you cannot adjust the set point. See To start or stop the growth curve in the user manual for more information.
    • Can the AutoFlex Connect-2 control heat lamps?

      To control heat lamps within the AutoFlex Connect-2 you would use a VAC-1 board. https://phason.ca/pdfs/vac-1.pdf Heat lamps can be controlled via a VAC-1 module, assigning the output as “Variable Heating”. Once you have the module configured, the ...
    • Variable lighting control in the AutoFlex

      Variable light control can be a complicated subject, as there are endless amounts of different light manufacturers, different bulb types, various methods of dimming, LED lamps with internal drivers versus external drivers. It can all get very ...