Related Articles
Check light sensor error
This error means that the control is not seeing a valid reading from the light sensor. In most circumstances this is a sensor/wiring problem that needs to be addressed. Please see DOL’s Technical User Guide for some more information.
Alarm Codes and Error Messages
ALARM MESSAGE POSSIBLE CAUSE POSSIBLE SOLUTION High Temp Probe 1 High Temp Probe 2 High Temp Probe 3 High Temp Probe 4 The temperature associated with a probe has gone above the high temperature alarm point and past any alarm biasing. Try lowering ...
EPF error
On the old PEC-PLUS the EPF error means the EEPROM has failed. To fix this a factory restore is required. Power off the control, and while holding down the up and down arrows, power on the control. If the error appears again, the control likely needs ...
Connecting to an AFX using the local network
To test if an AFX has successfully connected to the local network, connect another device to the same network, and then type the following into a browser (capitals matter): "internal IP"/afx/index.php?device="Hostname". For example, a unit with a ...
Can I restore an AFX2 database backup onto an AFX3?
Yes. This would most often occur when upgrading an existing AFX2 to an AFX3. You may take a database backup of the existing AFX2 and then restore that file on the AFX3 to mirror the settings onto the new control.