Is there a way to change the behaviour based on humidity levels?

Is there a way to change the behaviour based on humidity levels?

Yes. The high humidity bypass allows you to monitor humidity levels and skip the water portion of the cycle and only run the fan portion if the humidity is too high.

    • Related Articles

    • Can I control a pump strictly off humidity?

      Most equipment controlled from the PLUS-TOUCH must use temperature as a primary control mode. However if they set up a Cooling relay with a very high value setpoint, it should never turn on from temperature. Then, you can set up secondary modifiers ...

    • Temperature does not change

      Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...

    • Temperature does not change

      Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...

    • Can I change when my daily logs reset?

      No the change over is not adjustable and goes by the day itself.

    • How do I change the name of a stage?

      You can change the name of your stages from the Configuration menu.