How to get rid of OSD display settings menu that appears on my AutoFlex Connect?

How to get rid of OSD display settings menu that appears on my AutoFlex Connect?

The AutoFlex Connect display has its own built-in settings menu (OSD) for contrast, brightness, etc., like any other monitor or display. This is set at the factory, and should not appear on its own. If the menu ever appears, try carefully disconnecting both cables and power from the display driver board in the upper left hand corner of the control. Let the control run for a few minutes like this. The display will be blank (off) as there is no signal or power going to the display. Reconnect all cables and power to the display driver board, and the menu should no longer appear.

    • Related Articles

    • Why did my room / configuration / settings disappear after I power cycled my control?

      If you have a new AutoFlex Connect that is losing configuration or settings when the control is power cycled, you may have left the battery isolation tab in place. This tab prevents the battery from discharging during shipping or when the control is ...

    • How do I safely and properly power cycle the AutoFlex Connect?

      How to safely power cycle the AutoFlex Connect Note: If the control is frozen or the touchscreen is not working for some reason, skip to step 3. 1. Go to Menu -> Administration -> Diagnostics. 2. Press Shut Down Display. The control goes through a ...

    • Can the AutoFlex Connect-2 control heat lamps?

      To control heat lamps within the AutoFlex Connect-2 you would use a VAC-1 board. https://phason.ca/pdfs/vac-1.pdf Heat lamps can be controlled via a VAC-1 module, assigning the output as “Variable Heating”. Once you have the module configured, the ...

    • Why is my AutoFlex Connect screen blank or blue on startup?

      If the screen of your AutoFlex Connect turns on and then goes blank or blue when starting up, the backup battery in the control may need to charge. Open up the control and look at the back of the display for the board with the small fan. If L1 and L2 ...

    • How do I save and restore settings?

      Insert a USB into the control, go to the Administration menu, and then select either Save Settings or Restore Settings. For more information, see Saving and restoring settings in the Plus Touch user manual.