How do I tell if my control is in heating or cooling mode?

• Related Articles

• How do I configure my stages for heating or cooling?

  Stages 3, 4, and 5 can be configured for either heating or cooling. Do this through the Configuration menu. See the user manual for step-by-step instructions.

• How do I change between heating and cooling modes?

  Place the internal jumper in the correct position for the mode you want. See the user manual for more information.

• Can the FC-1T-2VAC-3F control variable heaters?

  No, the two variable stages are for cooling only. The three relay stages can control either cooling or heating. The Plus-Touch can control variable heaters.

• How can I control the humidity caused by my cooling cells?

  By using Stage 5's proportional cooling, you can truly run your cooling cells as evaporative cooling, by setting them to turn the pump on and off according to the proportional cycle. This will allow the fan to run by itself and pull the excess ...

• Can I control my floor heating in a different zone?

  Yes, the PLUS TOUCH has two available zones, so you can use one for controlling the room's main equipment based off the average of multiple probes, and a second one to control equipment off a different probe.