How do I switch between displaying Celsius and Fahrenheit?

• Related Articles

• Relay does not switch load off

  Problem Relay does not switch load off Possible Cause The relay is configured as ON Possible Solution Configure the relay properly.

• Relay does not switch load off

  Problem Relay does not switch load off Possible Cause The relay is configured as ON Possible Solution Configure the relay properly.

• Why is there a delay when I switch from manually overriden Open to Close?

  There is a three-second delay when switching between Open and Close. This is to allow the motor time to stop before switching directions.

• Should I switch off the power to add or remove modules?

  Yes. You should always fully power off the control before adding or removing modules.

• When switching an AST from AutoSort to HUI/FCO mode, is the base weight calculated off the AutoSort group 1, or the HUI/FCO Light group?

  Question: With the AST, you can’t change the % of base weight like the ASC, it’s determined off the lowest weight group start weight (65%). When you switch to HUI mode, does it stay based off the lowest weight group number in your auto sort settings, ...