Insert
a USB into the control, go to the Administration menu, and then select either
Save Settings or Restore Settings. For more information, see Saving and
restoring settings in the Plus Touch user manual.
Yes. This would most often occur when upgrading an existing AFX2 to an AFX3. You may take a database backup of the existing AFX2 and then restore that file on the AFX3 to mirror the settings onto the new control.
No. If you try to restore a database file on an Autoflex-Connect that was created by a unit running a newer version you will cause unknown and often weird bugs. First update the control with the older version to be the same or newer than the control ...
The AutoFlex Connect display has its own built-in settings menu (OSD) for contrast, brightness, etc., like any other monitor or display. This is set at the factory, and should not appear on its own. If the menu ever appears, try carefully ...
ALARM MESSAGE POSSIBLE CAUSE POSSIBLE SOLUTION High Temperature Alarm The temperature has gone above the high temperature alarm point. Try to lower the temperature by turning heaters down or off, or by increasing or turning on cooling elements (such ...
Step 1 - From the controller with all of the settings you wish to use; Go to Main menu > Administration > Diagnostics > Backup Database Step 2 - From the Diagnostics page, go to Eject USB and push Yes. Step 3 - With this "It is now safe to remove the ...