How do I configure my stages for heating or cooling?

• Related Articles

• How do I change between heating and cooling modes?

  Place the internal jumper in the correct position for the mode you want. See the user manual for more information.

• How do I tell if my control is in heating or cooling mode?

  Click the switch to the left. See the user manual for more information.

• Can the FC-1T-2VAC-3F control variable heaters?

  No, the two variable stages are for cooling only. The three relay stages can control either cooling or heating. The Plus-Touch can control variable heaters.

• What is the difference between direct and indirect evaporative cooling?

  Direct cools animals by soaking them in water that then pulls heat out of them as it is evaporated off of them. Indirect cools the air by inserting and then evaporating water vapour, a process which pulls heat from the air. For a more complete ...

• How can I control the humidity caused by my cooling cells?

  By using Stage 5's proportional cooling, you can truly run your cooling cells as evaporative cooling, by setting them to turn the pump on and off according to the proportional cycle. This will allow the fan to run by itself and pull the excess ...