Why is my main control working but my expansion box is not?

Confirm the expansion box wiring going from the master to the expansion.

The Heat Mat Box has a connector labeled SLAVE 1 for connecting Expansion Boxes. Connect the Expansion Cable from SLAVE 1A to SLAVE 1B. To connect additional Expansion Boxes, connect the cable from SLAVE 1A to SLAVE 1B.

• Related Articles

• Why am I getting different outputs on my main box and expansion box?

  Ensure that your main box, expansion box, and applicable mats are all connected to the same phase of power.

• Can I use a CABLE-XZ25 with an Autoflex Expansion box?

  The short answer is no. The AFX Expansion Box comes with a 6-foot cable to connect the expansion box to the main control. If you need them farther apart you need to purchase an AFX-EXTENDBOX25 kit. This kit allows them to be up to 25 feet apart, and ...

• Variable lighting control in the AutoFlex

  Variable light control can be a complicated subject, as there are endless amounts of different light manufacturers, different bulb types, various methods of dimming, LED lamps with internal drivers versus external drivers. It can all get very ...

• Can the AutoFlex Connect-2 control heat lamps?

  To control heat lamps within the AutoFlex Connect-2 you would use a VAC-1 board. https://phason.ca/pdfs/vac-1.pdf Heat lamps can be controlled via a VAC-1 module, assigning the output as “Variable Heating”. Once you have the module configured, the ...

• Can you connect multiple expansion boxes?

  No. You can connect a maximum of one. It can be either an EXPANSION-6 or an EXPANSION-14. Module outputs can be connected to expansion boxes to expand their load capacity though. For example: An FD-1-14 or FD-2-7 FanDrive connected to a VDC-4 output, ...