Does the neutral from the load need to go to the terminal on the VAC-1 ?

• Related Articles

• Questions about troubleshooting load cells

  The following information is available in the troubleshooting section of all scale head manuals. 1. Make sure the cage is not hitting against anything (for example, the floor, dung, part of the frame). The only contact points must be the load cell ...

• Relay not operating load

  Problem Relay not operating load Possible Cause Possible Solution Incorrect wiring Correct the wiring. Switch-on setting for stage incorrect Adjust the setting. Relay set to cool for a heater Relay set to heat for a fan No power to load Switch on the ...

• Relay not operating load

  Problem Relay not operating load Possible Cause Possible Solution Incorrect wiring Correct the wiring. Switch-on setting for stage incorrect Adjust the setting. Relay set to cool for a heater Relay set to heat for a fan No power to load Switch on the ...

• Relay not operating load

  Problem Relay not operating load Possible Cause Possible Solution Incorrect wiring Correct the wiring. Switch-on setting for stage incorrect Adjust the setting. Relay set to cool for a heater Relay set to heat for a fan No power to load Switch on the ...

• Module slot #9 doesn't fit the VAC-1 module

  Because of the design of the module and the placement of the screw that holds the board in the enclosure, a VAC-1 module will not properly sit in Module #9 of the AutoFlex. Use this slot for other modules.