Does the FC-1T-2VAC-3F have an empty room mode?

Does the FC-1T-2VAC-3F have an empty room mode?

Yes, there is the option to have ventilation off and only heat stages active. This is most often used when a room is empty and only needs to be kept from freezing. It also has multiple programs that you can use for different seasons or scenarios.

    • Related Articles

    • Can you run the FC-1T-1VDC solely in manual mode?

      Users may want to run the FC-1T-1VDC in manual mode rather than running off the temperature probe. The FC-1T-1VDC does have a software manual override menu that can be used to manually set the output. The controller will stay at the overridden output ...

    • Does the FC-1T-1VAC work with capacitive start motors?

      The FC-1T-1VAC has a rating of 7 FLA at 120/230 VAC for a PSC motor. PSC stands for Permanent Split Capacitor. So yes, the FC-1T-1VAC can operate capacitive start/run motors.

    • Module slot #9 doesn't fit the VAC-1 module

      Because of the design of the module and the placement of the screw that holds the board in the enclosure, a VAC-1 module will not properly sit in Module #9 of the AutoFlex. Use this slot for other modules.

    • Can the FC-1VAC be powered by 208VAC?

      Yes, the FC-1VAC can be powered by 208VAC.

    • Why does my fan stop when in Idle mode?

      The idle mode setting may be too low. Turn the Temperature knob fully clockwise. Turn the Idle Speed knob to the minimum fan speed desired. Turn the Temperature knob to the desired temperature.