Do FCO values automatically recalculate?
FCO is not automatically recalculated and must be manually recalculated with the option in the UI. It needs at least 100 hits from the previous day for the calculation to work.
Related Articles
When switching an AST from AutoSort to HUI/FCO mode, is the base weight calculated off the AutoSort group 1, or the HUI/FCO Light group?
Question: With the AST, you can’t change the % of base weight like the ASC, it’s determined off the lowest weight group start weight (65%). When you switch to HUI mode, does it stay based off the lowest weight group number in your auto sort settings, ...
Can my zone temperature be the average of multiple temperature sensors?
Yes. All sensors assigned to control the same zone are automatically averaged to calculate the zone reading.
Why is My AutoSort Connect screen blank on startup?
If the screen of your AutoSort Connect turns on and then goes blank when starting up, the backup battery in the control may need to charge. Open up the control and look at the back of the display for the board with the small fan. If L1 and L2 LEDs ...
Can I use misting, fogging, and soaking in a THI controlled equipment group?
Yes! THI misting/fogging/soaking looks exactly the same as in a cooling equipment group, only you will have THI values as the low/high/max setpoints rather than temperature values. There are three videos explaining the three modes available in the ...
What does a good ACT-1 calibration look like?
When calibrating an actuator with potentiometer feedback that is being controlled by an ACT-1, you will notice that the control gives you ADC readings. When the actuator is running the calibration you should see the ADC value increase as the actuator ...