Can this control more than one curtain?

Can this control more than one curtain?

Yes. If you want more than one set of curtains controlled exactly the same, and the combined motors are within the relay ratings, or you are using contactors, then you may control multiple curtains off one SPC-2.

    • Related Articles

    • Air curtain operation explained

      Air curtain settings This is the status and physical order of the air curtain bags. The numbers correspond with blower numbers in item B. This is the list of blowers, in the order they inflate. The blower button that is selected is the one that you ...

    • Can an ACT-1T control an inlet or curtain via a contactor?

      No. The ACT-1T uses the current sensor during the calibration process. If the ACT-1T is connected to a contactor that is switching the motors on and off, then it is not getting the current from the load, and will not calibrate or operate properly. In ...

    • Setting up an Inlet / Actuator / Curtain WITH Feedback

      Setting up an actuator in AutoFlex Connect These instructions are for actuators that require a feedback signal and will be programmed for traditional staged ventilation. The two main steps are configuration and programming. Configuration 1. Go to the ...

    • How to load a backup from one control to another?

      Step 1 - From the controller with all of the settings you wish to use; Go to Main menu > Administration > Diagnostics > Backup Database Step 2 - From the Diagnostics page, go to Eject USB and push Yes. Step 3 - With this "It is now safe to remove the ...

    • Can I control multiple heaters or fans with one FC-1T-1F?

      The limiting factor is the relay rating. Add up the current draw of the fans or heaters you want to control and then compare it to the relay rating. If the combined fans or heaters draw less than the relay rating then you can control them.