Can my zone temperature be the average of multiple temperature sensors?

• Related Articles

• Fans turn off and actuators close when zone temperature rises

  Problem Fans turn off and actuators close when zone temperature rises Possible Cause Tunnel mode is active Possible Solution Set tunnel turn off to "No" for stages you do not want affected by tunnel mode.

• How can I have multiple temperature sensor readings averaged to create my group temperature?

  All the temperature sensors that you assign to control an equipment group will be averaged to calculate that group’s reading.

• Why is my group temperature reading higher than the average of my two sensor readings?

  Check if there are other temperature sensors assigned to control that equipment group. A temperature sensor in a different room or an outdoor sensor could be incorrectly assigned to control for that group and is being added into the averaging ...

• Can I control my floor heating in a different zone?

  Yes, the PLUS TOUCH has two available zones, so you can use one for controlling the room's main equipment based off the average of multiple probes, and a second one to control equipment off a different probe.

• Why is my Plus-Touch temperature reading not changing?

  If your Plus-Touch temperature reading is stuck on one single temperature you may have the temperature manually overridden. Go to the Menu, then Manual Override. Either hit Auto All to change all outputs and sensors back to automatic operation, or ...