Do I have to turn the power off to change the modules?

• Related Articles

• Should I switch off the power to add or remove modules?

  Yes. You should always fully power off the control before adding or removing modules.

• How do I safely and properly power cycle the AutoFlex Connect?

  How to safely power cycle the AutoFlex Connect Note: If the control is frozen or the touchscreen is not working for some reason, skip to step 3. 1. Go to Menu -> Administration -> Diagnostics. 2. Press Shut Down Display. The control goes through a ...

• Temperature does not change

  Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...

• Temperature does not change

  Problem Temperature does not change Possible Cause Possible Solution There are no working temperature probes enabled or connected Make sure at least one working probe is enabled. The control is in temperature test mode. If the TEST LED is on, the ...

• SB-54 Troubleshooting OMNI Select

  Attached is a details document covering several different aspects of OMNI Select. -Troubleshooting communication problems -Complete communication overhaul -Using Toolkit -How to check for devices -Serial Port/Loopback tab -Multi-point PWAs tab ...