1640 (SUPRA-RS) Display damaged. What part do I need?

• Related Articles

• Can a Supra Touch display kit be used to upgrade a Supra-RS?

  Unfortunately, no. The control board for the Supra Touch is different than the one for the Supra-RS. A complete control will need to be purchased.

• Supra/Pbx-11/PEC - Can I use ECM motors?

  Supra-RS - The Supra can support up to 4 0-10v DC stages by adding a K210050 --10VDC expansion kit PBx-11 - The PBx-11 has 2 0-10v DC stage outputs located in the display board. *These two stages track the variable AC stages and are not independent ...

• Can the K210002-RS work with an older Supra?

  Yes, this is the newer revision and can replace older backboards, but will not be compatible with the SUPRA-TOUCH hardware.

• Display showing unusually high temperature

  Problem Display showing unusually high temperature Possible Cause Possible Solution Extension cable connected to temperature probe is providing a poor connection Check the extension cable connection. Resolder it if necessary. Damaged probe Replace ...

• Do I need the KPT-DISPLAY or KPEC-PLUS-TOUCH?

  The old version backboard has a big black heatsink on the regulator as shown below. This backboard requires the KPEC-PLUS-TOUCH kit. The new version of backboard has a small DC-DC power supply as shown below. This backboard uses the KPT-DISPLAY kit.